SCP instruction but my SCP is on steroids because now I can easily obtain the "m/Slope/Rate" of the line and also the Charleston, SC - Version D30 number that large will not fit into the 16-bit integer location N7:0 Chapter 8 Math Functions Introduction MOVE_BLK instruction when the data at the move destination address is not used within an interrupt OB subprogram or, if used, the destination data does not have to be consistent. Access to RSTune and RSLoopOptimizer from PID instructions in the RSLogix editor (this Requires RSLinx V2.31 or later for Topic creation) and rungs to include symbols and address comments when dragging between instances of RSLogix 500, or to RSLogix 5. Fixed the problem using floating Note 3 - The user may not specify a comparison of two constants within RSLogix 500. In other words, you may not use the NEQ instruction with "Operand A" set to 7 and "Operand B" set to 20. In other words, you may not use the NEQ instruction with "Operand A" set to 7 and "Operand B" set to 20. PLC Programming Advanced Mathematical Instructions - SCP | Scale With Parameters PLC Alarm Programming - Fault Capturing Example in Ladder Logic RSLogix 500 Allen Bradley Gallery The Floating Point constant is not supported in an SCP instruction. RSLogix 500 does not allow the use of a Floating Point constant in an SCP instruction. Compatibility issues occur when using an older version of RSLogix 500 with the MicroLogix 1100 Series B controller. RSLogix 500 programming package is compatible with programs created with Rockwell Software DOS-based programming packages for the SLC 500 and MicroLogix families of processors, making program maintenance across hardware platforms convenient and easy. A firmware change in the implementation of the MSG instruction between the OS500 and OS501 SLC 5/05 processors requires that you delete and re-enter all MSG instructions in any SLC 5/05 programs created with RSLogix 500 r2.10.12. INSTRUCTION - RSLogix's Relay Ladder