The camera initially should be connected via the following method: The camera uses a POE cable for internet access, as well as to power the camera. 3.2 Installation Guide The camera has a standard camera tripod screw hole (1/4-20 UNC thread) for use in mounting the camera onto a stable surface. ecl-ips.com refer to Section 2.2 Setting the Network Camera over the WAN. 2.1 Setting the Network Camera over the LAN Purpose: To view and configure the camera via a LAN, you need to connect the network camera in the same subnet with your computer, and install the SADP or iVMS-4200 software to search and change the IP of the network camera. Ensure camera and mount are firmly fixed in-place before use to avoid falls Keep away from liquids, extreme heat, and strong magnetic fields Ensure the operating temperature is within the range: -30°C - 75°C (-22°F - 167°F) Avoid touching the lens surface. It may be cleaned with a cotton swab or lens cleaning paper. Hikvision How to Video Guide Series from NetviewCCTV.co.uk ALL the latest Hikvision CCTV Surveillance products available on www.netviewcctv.co.uk UK's leadin Find and download the latest firmware for your IP camera, V4.02.R12 IPC based on Hi3518E, Hi3518C, Hi3516A, Hi3516C, Hi3516D, GM8135S, GM8136S, XM510 SoC www.vitekcctv.com HIP2P IP Camera CMS user manual Page 11 ON page 19 2.5. PTZ control 2.5.1. PTZ control You can control PTZ of eight directions rotation by direction key, and choose PTZ rotate speed by drag slider, "-"means PTZ rotate speed slow down, "+"means PTZ rotate speed up. Iris ehlarge button, need the lens of camera support www.dahuasecurity.com IP Address amera's local network IP address, which is used to view the camera in the same local area network. Specify a unique IP address for your network camera. Subnet Mask Specify the mask for the subnet the network camera is located on Gateway Specify the IP address of the default gateway (router) used for connecting To view and configure the camera via a LAN, you need to connect the network camera in the same subnet with your computer, and install the SADP or CMS software to search and change the IP of the network camera. Note: For the detailed introduction of SADP, please refer to Appendix 1. 2.1.1 Wiring over the LAN Was this article helpful? 0 out of 2 found this helpful. SHARE. Have more questions? Submit a request To view and configure the camera via a LAN, you need to connect the network camera in the same subnet with your computer, and install the SADP or CMS software to search and change the IP of the network camera. Note: For the detailed introduction of SADP, please refer to Appendix 1. 2.1.1 Wiring over the LAN Was this article helpful? 0 out of 2 found this helpful. SHARE. Have more questions? Submit a request The IP cameras can be applied as a part of a safety surveillance network. With the professional network video surveillance software it achieves the strong network communication ability and telecommunication ability. And IPC can individually work also.